Increase max parallel loops on deployed executable

[Andrey_Dmitriev · Accepted solution]

---

@altenbach wrote:

You need to set it in the parallel configuration and wire the desired number to P. If P is not wired (as in your case), it will use the number of CPU cores.

---

That is the good point! And here not only desired numbers, but also the value "-1" can be used, then this value will be taken from  configuration dialog box. In such cases I also wiring chunks and set it to 1 (but this not always necessary):

[RHryniowski]

This worked, I had configured the Number of parallel loop instances via the dialog box and had assumed this was the setting that would be applied.   Thanks for the fix Andrey_Dmitriev and everyone who helped!