Help with Control Design and Simulation to make block

[Vendetta]

Good Morning:

I'm making a Simulation to the Transformer in the Linear Case, The Diagram of Blocks that i used is a Diagrarm to make it in Simulink But i want to make this in Control Design and simulation, apparently is the same way but, i have error in my Simulation, where is it?   I checked Subdiagram by Subdiagram but i don't found the error, might you help me please?.

I checked Subdiagram by Subdiagram but i don't found the error 

After of that, i want to make a saturation in the signal but i don't know hI checked Subdiagram by Subdiagram but i don't found the error, might you help me please?.

After of that, i want to make a saturation in the signal but i don't know how, 

attached file (file subsystems and general) in addition to the block diagram format. doc, The Diagram belong to The book: 

Dynamic Simulations of Electric Machinery: Using MATLAB/SIMULINK

Chee-Mun Ong

Thank you guys for your help, i really need to know this subject

Vendetta.

PD sorry but i don speak english very well, i'm from Guatemala, i'm starting to learn. 🙂

[BeCeGa]

Duplicated Post:

http://forums.ni.com/t5/LabVIEW/Simulink-a-Control-design-a-simulation-aydua-con-modelo/td-p/1179853...

[Vendetta]

i'm sorry you right, how can i erase a post?

[BeCeGa]

Hi vendeta the post cant be erased. I placed  the link in case somene found it, they can go to the forum with the answer

Best regards