FPGA target visible in MAX but not in LabVIEW

[Alann]

Hey!

I recently installed a RIO device. Before installing the hardware, i installed FPGA module & RIO 3.0 as directed. Now i can see the device in measurement & automation explorer, but its not in 'Add targets & devices' list. It says 'No devices found' in existing devices tab. I cant understand the problem. 😕

[Christian Mergl]

Hey,

What RIO device is it? R-Series or cRIO, or ...?

Where do you add the target, under "my Project" or "my Computer" ?

Christian

[Alann]

R-Series & i tried to add the target in project

[AdnanZ]

That's interesting...seems like a similar post to this:

http://forums.ni.com/ni/board/message?board.id=280&message.id=6481

Try to follow the suggestions mentioned in there and post back if you still have issues.

[Christian Mergl · Accepted solution]

You have to add the target under "my computer".

Christian

[Alann]

Yes Adnan, my problem is very similar to this. But reinstallation didn't solve the problem. Card doesn't show up in targets and devices, under exisiting target or device.
 

[Alann]

Hey!! Thanks all!! I re-installed and added the target in 'My Computer'. The card is visible in FPGA targets. 🙂

[thej178]

Been stuck on this for hours. THANK YOU