FPGA create variable crash

[Eric416]

crio  9014, 9114 chasis, labview 11

If I create a lvlib under the 9114 chasis FPGA target and then click "create variables" in that library, whenever I click ok to create the variable it will crash to the desktop.

I found this issue in my current project but if I create an new blank project I get the same result.

[Doug-B]

Hey Eric,

I tried to reproduce the behavior you were describing on my end and I was not getting the same result. I was able to create the variables from the lvlib under a 9114 FPGA target. This leads me to believe that the issue might be with your LabVIEW FPGA module. I would try to repair that module and see if that solves your issue.

Hope This Helps,

Doug B

[Eric416]

I have installed sp1 for labview 11 , still crashes

did a repair of the fpga module (from programs in control panel?)

Still crashes

[Doug-B]

Hey Eric,

Check your services to see if your Shared Variable Engine is running. The other thing I would suggest is to try and programmatically create your shared variables and see if you get the same behavior. Here is a good example you might be able to use to test this:

https://decibel.ni.com/content/docs/DOC-12548

Hope This Helps,

Doug B

[Eric416]

Shared variable service is running.

Running the sample project you linked to work properly, a new variable was created without issue.

I am not using them in my current project, so its not a critcal issue for me yet.