Error code 28 LabVIEW Null menu

[gpaito]

The error cluster of my VI indicate that the error 28 : LabVIEW Null menu occur in it, but when I open the block diagram  of this VI to see which subVI cause the error, the error doesn't reappears anymore and everything is OK.

Afterward, if I close my erroneous VI and run it again. The error Reappears. I try a MASS COMPILE but I still have the same problem. So I have 2 questions.

1) What can cause the apparition of the error when I run my application normally and not when I open the VI block diagram.

2) What can cause the Error: 28 : LabVIEW Null menu.

Thank you for your answer
Gpaito

[K C]

Hi,

Post the VI's if possible.

[gpaito]

What do you mean post the VI's ?

J.-P.

[K C]

Hi,

This is over 1 year old ?!?!  

What i mean is that you can add your VI to a meesage so we can have a look at it

Message Edited by K C on 02-26-2007 09:31 PM

[gpaito]

I know it’s over one year old, but it’s an intermittent problem. And I will post the VI this problem return, because for the last 2 months everything is fine.

J.-P.

[K C]

OK, sorry for my reaction    but in the first message is looked like a urgent problem.

I'll wait for the VI