Error: Hex 0xBFF60492

[KvonK]

Hello together,

I wanted to use a Sanyo Xacti CG 10 video camara in LabView.

By using the NI-IMAQ for USB Snap I get the following error: IMAQ Vision: (Hex 0xBFF60492) Ungültige Blit-Funktion des Videoausgangs.

Is it possible, that I can not use this camera in LabView?

Driver are up to date for the camara and IMAQ.

Thanks a lot for your reply

[Stephan_D]

Hey KvonK,

some further information would be helpful for me and the other people in the forum. Can you see the camera in MAX? Is it possible to get a picture from the test panel in MAX?

It would also be very helpful, if you post the used VI.

And because I understand the german error text: Is "Blit-Funktion" the real error message text or only a typing error?

Regards, Stephan

[KvonK]

Hello Stephan_D,

thank you for your answer.

I can see the camera in MAX and it I can see the video directly (Attachment)

The name of the used VI is "NI IMAQ for USB snap_VBAI stab.vi".

The error which I get with this VI is :"IMAQ Vision:  (Hex 0xBFF60492) Ungültige Blit-Funktion des Videoausgangs.".

I tried it also in the NI Vision Builder, but there I get only the mistake "No NI-ImaQdx Camera Connected".

I hope you can help me.

Best regards

Christian

[Stephan_D · Accepted solution]

Hi Christian,

please try to acquire a image with the attached VI. Do you also receive a error message with this programm code, if you choose your USB Sanyo Xacti CG 10 and run the VI?

Regards, Stephan

[KvonK]

Hello Stefan,

thank you for your reply.

With this VI I am able to get the video from the Sanyo Xacti CG 10 into LabView.

In this way I can proceed the data in my way.

Best regards

Christian