Edge Strength Profile

[D60]

Hi! I would like to create an Edge Strength Profile. I found a link:: 
http://digital.ni.com/public.nsf/allkb/34E524B23E9B88C28625711D000E2027

and tried to do the same... but the result is different in code and profile too. I could you help me to correct it?

I attached my solution:

[muks]

I assume you would have seen this line in the knowledge base article

"Understand that the method above will create an edge strength profile that does not exactly match the edge strength profile found in Vision Assistant and VBAI.".

Can you post your orginal image?

[D60]

Hi!

The Image from VBAI - Battery Inspection:

BTW, The Derivative function prameters in the site are not accepted by the function...

[raph.yyz]

Any Suggestions?

Thanks

[D60]

Here is NI solution!

http://digital.ni.com/public.nsf/allkb/34E524B23E9B88C28625711D000E2027

I used this one!

[raph.yyz]

Hi,

Any solution including the filder width and steepness parameters (similar to Vision Assistant)?

Thanks