EIOXNodeErrorStruct.ctl exits labview when selected

[J.Willems]

Hello there,

Just like the title already says, I have some software that a person before me made using the cRIO 9101.

Every time I try to open the software it is asking me to point out some .ctl files.
When I am searching after them on my hard disk, I am selecting them.
And every time I select the EIOXNodeErrorStruct.ctl then the labview gives the error I attached and just closes...

Is there anybody who ever had something like this?

What should I do against it?
Thanks in advance for the help.

[ThiCop]

Hello J.Willems,

Do you have information about the LabVIEW version in which the original application was made?

Do they use self-made XNodes in this application?

Is it possible to share the application/code with me?

Which NI software set-up are you using?

If you could share a MAX Report with me, then this might provide me with some valuable information:

http://digital.ni.com/public.nsf/allkb/271F252B4EF0A2E0862570E70056A1E4?OpenDocument

[J.Willems]

Hello ThiChop,

I completly reinstalled my labview setup, and now the problem is solved.
The persons from NI Belgium think it is there was a problem with one of the dependencies.
Now I can open and run the program.

Thanks for the reply.

[J.Willems]

Hello ThiChop,

I completly reinstalled my labview setup, and now the problem is solved.
The persons from NI Belgium think it is there was a problem with one of the dependencies.
Now I can open and run the program.

Thanks for the reply.

[ThiCop]

Hello J.Willems,

Thanks for letting me know!

Alot of success with all your programming!