Dynamic VI Problems

[ssk]

Yes it will run OK on its own.

[User002]

---

Any ideas would be greatly appreciated!

---

Have you tried this on the "problematic" VI:

Perhaps this before calling the VI?

Not sure if it helps though.

Br,

/Roger

[BillMe]

Make sure "Remove Front Panel" is not checked under Source File Settings in the Build Properites.

And can you post the code?

[ssk]

Thanks for all of the suggestions.

I think I may be suffering from some kind of compiler bug. By process of elimination I worked out that there was something on the front panel/block diagram that was causing the problem.

If I create and call test.vi (instead of datalogger.vi) and just have a loop with delay and stop button, the main code will call and display the subvi as expected.

If I copy the block diagram code from datalogger.vi and paste it into test.vi then it stops working.

I have slowly been deleting section of code until it worked and there are two X-Y graphs that seem to be causing me a problem. If I delete one, it still does not work. If I reinstate that graph and delete the other, it does not work. If I delete both of them it works!!!

Very bizarre.