Dynamic Data Processing

[Ram73]

Hello 

Can anyone please let me know how to do frequency analysis after the data acquisition. I know LabVIEW has tone measurement to measure the frequency, amplitude and phase, but I wanted to use single phase PLL to measure the frequency. The attached picture has my reference PLL diagram. Can any one suggest me the possible approach to build the PLL in LabVIEW to process the waveform signal. My acquired signal is in the form of wavefrom. 

Thank you

Ram

[OctavioS]

This thread has some good examples:

https://forums.ni.com/t5/Example-Programs/PLL-Phased-Locked-Loop/ta-p/3492731

[Ram73]

Hello OctavioS

I referred that page earlier, in that examples they used the amplitude and frequency measurement block, but I want to construct the model as shown in the picture. I wanted to measure the quantities after processing the data. 

Thank you

Ram