Digital Display format bug?

[elset191]

I have an enum (happens to be a typedef) with the Display Format set to %.1d_0x%x so I can see decimal and hex representation.  When I turn on the digital display on the control it works fine.  If I turn the control into a constant the display format only shows the decimal part.

[elset191]

Edit time up already?

It's a ring, not an enum, but it behaves the same way in both cases.  Also, when the Display format is set to just "%x" it still shows in decimal on the block diagram.

[BenDAE]

Nice find! It actually changes the format to floating point. I am filing a Corrective Action Request. We always appreciate these type of finds. 

[elset191]

You can manually change each one individually once it's constant. Easy workaround

Can you leave the CAR here when you get it

[BenDAE]

Absolutely! Your CAR # is 318263.

[BenDAE]

This was reported to R&D (# 318263) for further investigation.

Although it was submitted 10/10/2011, I am following NI discussion forum protocol by posting here properly. I have no updates to share at this point. However, I will take this time to again personally thank you for taking the time to point out the bug.