Data type conversion using Arduino Toolkit

[DESERT RACE]

Hello everyone,

I am just starting out with LabVIEW and the Arduino Toolkit. I have a problem sending desired output to the Arduino's digital pin. I have attached the VI to show what I have done so far and what I am trying to achieve.

The basic idea is that my setup brakes the sine signal into bunch of pulses and then I want to output this pulses to Arduino (version of PWM).

In the attached VI I have left the wrong connection as it is in order to show where I am stuck. The problem is converting/braking 1-D Array of word integers into single byte of integers. I might be doing something wrong in my setup and end up with the wrong data type.

I appreciate any input and help!

[dbell0971]

Hi DESERT RACE,

We have a dedicated forum to LabVIEW and the Arduino Toolkit at www.ni.com/arduino.  I would recommend posting your question under the discussions tab there as you will likely get a much faster and more applicable response.

Thanks,

David

National Instruments

Applications Engineer

[DESERT RACE]

Hi dbell0971, I figured out the solution myself. Actually it is Array realated Arduino was in the VI just to show where the output was going. 

This thread can be closed or deleted.