DOG Series Inclinometer

[MoShahin]

Hey guys i am started recently with Labview and i got  a Task from my Boss where i must Implement this analog signal Inclinometer(Datasheet are attached) on Labview and make some measurements (X -axis the tilt and y-axis the voltage) and honstley i have not so much idea, so can anyone help me, which ni-modul i should use and maybe i example programm that i can understand it.

I would me so thankful if anyone can help me.

Thank you

[GerdW]

Hi Mo,

---

@MoShahin wrote:

i have not so much idea, so can anyone help me, which ni-modul i should use and maybe i example programm that i can understand it.

---

You can use a cheap USB600x DAQ device to read those two 0.5-4.5 V signals, generated at (max) 100 Hz sample rate…

You will find a lot of example VIs in the example finder!

[MoShahin]

i have for example the Ni 9233 module its an analog modul, i used it for the accelerometer and measured the amplitude with the time with it.

So can i use it also for the inclinometer and can you show me which example VI i can use for the test. 

Best Regards

Mo

[GerdW]

Hi Mo,

that NI9233 is made for IEPE sensors and quite some overkill for your inclinometer. I'm unsure about the current excitation used in this module, as I have not used such a module until now.

Do you have a more "simple" voltage measurement module available?

[MoShahin]

Hi Gerd,

I have the Ni 9201 thats for voltage measurement, can i use it?

And which Example VI you would suggest ?

Best regards

Mo

[GerdW]

Hi Mo,

yes, you can use a NI9201 module.

Look up DAQmx example VIs, start with the easier ones (about continuously measuring a voltage signal)…