LabVIEW
Creating RF Cascade Analysis App
Within LabVIEW, I tried to create two VIs with the ultimate goal of using the Drag and Drop features to generate a new control once this is dropped. This control will be linked then to create a cascade set of objects such as amplifiers and attenuators to make a whole systems circuit and provide a graphical output at the end. Attached are two VIs, one the testbed for components which is where these are dropped and placed into a sequence along with a line and each one of these will acquire its properties. The second screen is the SideBar where components are located, such as amplifier and attenuator. Each will be added other properties to make further calculations and graphics in the middle or end of the RF Chain.
What I am asking is, how to drag and drop each individual component (now is a picture, but it could be anything else), into the area to drag and drop, and then add a connection between the components to create a cascade.
Something similar to the following, but not so complicated 🙂
https://www.mpdigest.com/2017/10/26/an-rf-simulator-for-enhanced-cascade-system-analysis/
@Jumig wrote:
Within LabVIEW, I tried to create two VIs with the ultimate goal of using the Drag and Drop features to generate a new control once this is dropped. This control will be linked then to create a cascade set of objects such as amplifiers and attenuators to make a whole systems circuit and provide a graphical output at the end. Attached are two VIs, one the testbed for components which is where these are dropped and placed into a sequence along with a line and each one of these will acquire its properties. The second screen is the SideBar where components are located, such as amplifier and attenuator. Each will be added other properties to make further calculations and graphics in the middle or end of the RF Chain.
What I am asking is, how to drag and drop each individual component (now is a picture, but it could be anything else), into the area to drag and drop, and then add a connection between the components to create a cascade.
Something similar to the following, but not so complicated 🙂
https://www.mpdigest.com/2017/10/26/an-rf-simulator-for-enhanced-cascade-system-analysis/
Not a direct answer but maybe some inspiration. The LabVIEW devs over at Qorvo made this awesome app:
available for free here:
https://www.qorvo.com/design-hub/design-tools/interactive/matchcalc
