Control Desing and Simulation Module

[antoniosaninge]

I need this toolkit to open and probe and example called: Simulating a Wind Turbine

I installed the evaluation version and it appears activated at NI license manager, but when I try to open the Final Simulation.VI Labview shows that there are some errors and warnings.

Do you have any idea about what is wrong?

I have attached Ni license manager and an error list

[CataM]

Hi,

Which version of the Module do you have ?

You need the support for LabVIEW 2017.

[antoniosaninge]

Hi Cata I finally solve it.

I have 2017 versión, the problem was that It only Works for 32bits versión, now it works

[Hash99]

I tried to run the simulating wind turbine file, but i am not able to run.

Its showing a lot of errors. 

Can you please help me rectify and provide necessary details to run it.

[GerdW]

Hi Hash,

---

@Hash99 wrote:

I tried to run the simulating wind turbine file, but i am not able to run.

Its showing a lot of errors. 

Can you please help me rectify and provide necessary details to run it.

---

Which errors do you get?

Do you have the needed toolkits/modules installed (like CDS)?

[Hash99]

I am using 2015 version, i wanted to know the name of  required toolkits and libraries required.

Please help with the procedure.

[GerdW]

Hi Hash,

---

@Hash99 wrote:

I am using 2015 version, i wanted to know the name of  required toolkits and libraries required.

---

From the first message in this thread I guess you need to "Control Design and Simulation" (CDS) module to run that example VI.

Do you have a license for the CDS module? (Well, you might install it in evaluation mode and run the example VI for a short period of time…)