I have just installed LabVIEW and I am working thru the tutorials in the Getting Started Manual. I am at the point where I am adding a Formula to the Generate and Display example VI. When I place the Formula Express VI on the block diagram I expect to see the Configure Formula dialog box. No such dialog is displayed. There is a grey box with no other information placed on the block diagram. Also, the run buton is shown as 'broken" such that I cannot 'Run" the VI. I do not have a clue what could be going on here and I am wondering if there was a problem during installation that leaves me without Formula support. I have not had any problems with placing and configuring any other VI's.
Please offer any thoughts or suggestions on how to solve this!
Thanks,
Mike
