Hello, I have acquired two signals, with a USB 9215A data acquisition board. The signals have 131072 samples each and the sampling frequency was 20kHz, the sampling period was 1/20kHz = 0.00005 seconds. (They are attached). I was trying to calculate the Coherence Function between the two signals. My problem is that I get the error which is presented in the image. As i understand, for a Signal, the dt parameter indicates the sampling period. The error states that the dt for my signals is <=0. How can I fix this???? Is there something wrong with my calculation??

ni.com is currently undergoing scheduled maintenance.

Some services may be unavailable at this time. Please contact us for help or try again later.

LabVIEW

Hi Raul,

I would like to point you towards an NI Tutorials on LabVIEW 2010 MathScript RT Module Known Issues. Please check and see if you are getting issues listed on the Tutorials.

Regards

Jig P

Best Regards,
Jignesh Patel
Principal RF Software Engineer

Message 11 of 12

(1,009 Views)

Thanks a lot Raul! I'm going to use Labview 9.0 to open it...

daqboy

Message 12 of 12

(992 Views)