03-16-2018 11:59 AM
When I start a new project and select target devices, labview will always automatically select FPGA mode. According to the instruction, there should be a step to select the SCAN mode or FPGA mode. Why it does not appear in my system? Thanks
I used NI cRIO-9014 with cRIO-9101 chasiss. The software is NI-compactRIO 15.0.
Thanks a lot for the help.
Solved! Go to Solution.
03-16-2018 02:53 PM
Hi,
What do you mean by "I used NI cRIO-9014 with cRIO-9101 chassis" ? How is your hardware setup ?
From what I read, I think you cannot use Scan Mode with cRIO 9101 but only with module inside the 9101 : http://zone.ni.com/reference/en-XX/help/373197G-01/target6devicehelp/supported_hardware_rt/
03-16-2018 03:08 PM
Thanks! You are correct. Chassis 9101 does not support Scan mode. But It seems like Hybrid mode is ok.
Thanks for the help!