Building an executable hangs Labview

[FireFist-Redhawk · Accepted solution]

What is your I: drive? Network drive? Thumb drive? The last line of your build log shows a source file that exists in your I: drive. If you've tried every other suggestion, I would move that file somewhere on C: and try again.

Or before that, make another simple VI and try to build it, but include that VI that exists in the I: drive, it's located at (get ready)...

I:\Projects\WTK\Hardware - Layout - Labview\cRIO - MyRIO\Microman Laser Setup - Krishna\Microman V3\Analog Discovery\Digilent_WaveForms_Stimulus Response (MSO + DIO Tom).vi

If that VI can be built, then I guess nevermind 😅

[Rockyenco]

Hi RedHawk,

Moving the build location to c:\ was indeed the solution.

However, like you suggested, i also made a simple .vi (switch and indicator) and this was able to be build onto the network drive.....

So finally, case closed.

Thanks all.