03-14-2010 05:27 AM
03-14-2010 06:36 AM
Currently the LabVIEW FPGA Module can only target National Instruments' own FPGA products. Therefore there isn't a driver that will support other boards with FPGA's.
Quote from the license
agreement:
...INSTALLATION
AND USE OF THE LABVIEW FPGA TARGET MODULE FOR THE XILINX SPARTAN-3E
STARTER BOARD (THE “TARGET MODULE”) IS LIMITED
TO ACADEMIC INSTITUTIONS THAT HAVE A VALID, CURRENT “ACADEMIC TEACHING
LICENSE” FROM NATIONAL INSTRUMENTS FOR THE LABVIEW FPGA MODULE.
THIS TARGET MODULE MAY ONLY BE USED FOR
INSTRUCTIONAL PURPOSES, SUBJECT TO THE TERMS AND
CONDITIONS OF THE NATIONAL INSTRUMENTS SOFTWARE LICENSE AGREEMENT THAT
ACCOMPANIES THE SOFTWARE...
03-14-2010 06:56 AM - edited 03-14-2010 06:57 AM
Thank you
And what about LabVIEW Embedded Module for ARM Microcontrollers ??
Is there same limitation ?
03-14-2010 07:21 AM
The LabVIEW Embedded Module for ARM Microcontrollers can be used to program over 260 ARM7, ARM9, and Cortex-M3 based devices only. Not sure if that's relevant to the original question you asked. To find out more about the list of ARM devices that are supported:
03-14-2010 03:56 PM - edited 03-14-2010 03:56 PM
03-15-2010 07:16 AM
03-16-2010 11:26 AM
Hi Mostafi,
When using LabVIEW for ARM, the microcontrollers are typically programmed through JTAG. For specific ARM device support, you can take a look at the here: http://zone.ni.com/devzone/cda/tut/p/id/7066
Regards,
Will S.
NIC-AE