Automatic code running after reset

[Donald_]

Hello,

where and how do I have to locate my code to build an application that runs by itself after a reset?

[Michael.Phillips]

I assume you are asking how to program the Flash of the Blackfin EZKIT. If so, read this KnowledgeBase article to learn how. [article no longer available]

[Donald_]

Thanks 🙂

[Donald_]

Hello does somebody know the cause of this fault?

Have a look at the attached file.

Best Regards 

[Michael.Phillips]

You're missing an argument. I noted it in bold text below.

elfloader MyApplication.dxe -b flash -f hex -Width 16 -init "init_code_bf537_ez-kit_lite.dxe" -o MyApplication.ldr -si-revision 0.2 -proc ADSP-BF537

[Donald_]

I am sorry I printed it out and there was no proc 😞 on my sheet Thanks

[LRoy]

Michael,

I have successfully flashed a labview demo to the EZ-Kit, but it takes a very long time to flash a 978k LDR file....like on the order of an hour....is that normal?

Thanks,

Larry

P.S. Here is my Flash dialog and the settings that I used...

[Tommasogallo]

How I can cancel the code inserted in the memory Flash ?

[Michael.Phillips]

You can't "un-program" the flash and get what was there before. If you want to program the flash to code that it comes with, see the files in this directory: "VisualDSP 4.5\Blackfin\Examples\ADSP-BF537 EZ-Kit Lite\Power_On_Self_Test\".

[Tommasogallo]

I want to make an other question .

I am working with LabVIEW 8.2 Embedded Module for ADI Blackfin Processors (BF537). I can implement on Blackfin BF537  the VI  "ICA" that is found in  the Advanced Signal Processing toolkit ?

Please, I waited for an answer because I am working to a search plan about the signals EEG .

Thanks .