ni.com is currently undergoing scheduled maintenance.

Some services may be unavailable at this time. Please contact us for help or try again later.

Home Community Discussion Forums Most Active Hardware Boards Instrument Control (GPIB, Serial, VISA, IVI) Topic

Instrument Control (GPIB, Serial, VISA, IVI)

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

modbus

modbus

‎03-09-2015 09:49 AM

Hello!

 
I am a beginner in Labview and I need to write a program, so please help. I am using two temperature controllers set temperature using the MODBUS protocol. I do not know how (after comparing the set and actual temperature) have the command "heat" . All I know is that the registry 25 I save the value 2 with Preset Single Register command. In Annex Vi. Thanks in advance for any advice.
0 Kudos
Message 1 of 2
(4,474 Views)
Reply

Re: modbus

‎04-13-2015 06:27 AM

 

Somehow it worked 😉  I think it is about closed.
0 Kudos
Message 2 of 2
(4,304 Views)
Reply