I am having the same problem as Bilaln. I was wondering if this problem was resolved or not? I read in another post that you got in contact with Carlos, the same person that I have been in contact with. He hasn't replied to the email that I sent about this error yet, but I think that he should be able to answer this. I just want to post this here to make it public.
My application uses two AF-1502 MoviMED on a single NI cRIO9024 system. The AF-1502 is a framegrabber made by MoviMED that hooks up to a camera. This project uses a AF-1501 driver at the FPGA level, Real-Time Drivers at the RT level, AF-1501 example code at the RT level, and a Bus Clock on the derived clock. I am using LabVIEW 2011.
I previously was able to get an image from the framegrabber, but now I get the same error.
This is the steps that I take before I get the error:
I compile the AF-1501 Driver and it compiles successfully.
I open the example code and it compiles successfully (at this point the it should have an image displayed).
I go to configuration on the front panel and go to configuration.
In the error box, the status has a red x on it and the code says 5387
The box reads AF-1501 Error Code.vi<ERR>
AF-1501 module timed-out during image acquisition.
What happened previously was that the AF-1501 Driver would have the start button push in and out and it would get a frame each time it did that. Now it only does that once and then stops. If I press that button manually with the mouse it does grab a frame.