hi all,
I am now developing the control for Tektronix 210 Oscilloscope. I know there is a instrument driver for it.However, I really dont know how do use it and where to start my work! can anyone give me some way how to do it? MY task is to configure the following :
(1) voltage up/down/1/2/3/4/5
(2) timebase up/down/1/2/3/4/5
(3) channel 1/2
(4) autoset on/off
It is not neccessary to read anything from the scope. Can Instrument driver be used for completeing the above task? Is it easy? Because time is limited.
Thanks anyone for help
(4) trigger falling/rising
(5)
