Hello all !I am a new labview user and I am trying to control the power supply as I attached labview VI driver . I want to step voltage start from 0V increase by 0.01 V up to 10 V ;and then from the current 10 V to decrease from 10 V to -10 V and then from -10 V to 10 V again . And then I automatically reset 10 V to 0 V .It will be be continuous llo circle until it reset to V.I am a student and I tried to make it quite a long time. It would be great help for any suggestions/ opinion or example? I have to read many contributions in this forum. But I could not do successfuly with short time.Thanks you all in advance.Toyota

Instrument Control (GPIB, Serial, VISA, IVI)

How can I control power supply by steps

Author

Dear Mr.Albert,

Your help is greatly appreciated. It worked well and you did very good example. Thanks for all the support and kind explanation.

Sophie

Message 41 of 41

(907 Views)

Instrument Control (GPIB, Serial, VISA, IVI)

How can I control power supply by steps

Re: How can I control power supply by steps