ni.com is currently undergoing scheduled maintenance.

Some services may be unavailable at this time. Please contact us for help or try again later.

Home Community Discussion Forums Additional NI Product Boards DASYLab Topic

DASYLab

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

block size

block size

‎10-20-2014 07:34 AM

Good Morning! I'm trying to open an ASCII file, which was collected through MegaWin software. However, when trying to open I get the following message: "The Set block size is larger than the number of lines in the ASCII file". I need to run the file in order to pass a filter on data from electromyography. If anyone can help me I will be very grateful!

0 Kudos
Message 1 of 3
(5,763 Views)
Reply

Re: block size

‎10-20-2014 09:47 AM

The Read Data module defaults to using the Driver timebase. If you don't have enough samples to fill a block, then you encounter this error message.

Click on the Ascii options setting to change the sample rate/block size to one that reflects your data. You need a block size of more than 1 to use the digital filters.

Measurement Computing (MCC) has free technical support. Visit www.mccdaq.com and click on the "Support" tab for all support options, including DASYLab.
0 Kudos
Message 2 of 3
(5,758 Views)
Reply

Re: block size

‎10-21-2014 06:49 AM

Ok! Thanks for your help and attention!

0 Kudos
Message 3 of 3
(5,741 Views)
Reply