Unable to View Transmitted Messages in NI-XNET Bus Monitor

[Mapwar96]

Hi everyone,

I'm currently using the NI-XNET Bus Monitor to observe CAN communication between two systems. While I can successfully see the messages being received, I'm unable to view the messages that are being transmitted from one system to the other.

Has anyone encountered this issue before? Are there specific settings or filters that need to be configured to view transmitted messages? Any guidance or troubleshooting tips would be greatly appreciated.

Thanks in advance!

[ZYOng]

Under Interface and Database Settings, enable Log Transmitted Frames.

You might want to set the Run Mode to Subordinate.

[FeSe]

Hi @Mapwar96,

This issue has come up in several threads and is often related to session configuration, filtering, or hardware setup. Here are a few things to check:

Configuration & Filtering

• Session Mode: Ensure you're using the correct session type (e.g., Frame Output or Signal Output) and that the interface is not in loopback mode.
   Cannot transmit messages in XNET Bus Monitor – NI Forum
• Filters: Check if any filters are active in the Bus Monitor that might be hiding transmitted frames. Try disabling “Show Only Filtered Frames.”
   NI-XNET Troubleshooting Guide
• Log Transmitted Frames: If you're transmitting from LabVIEW, make sure the Bus Monitor is set to Subordinate mode and that Log Transmitted Frames is enabled.
   Display Transmitted and Received Frames in NI-XNET Bus Monitor

 Hardware & Bus Setup

• Termination & Baud Rate: Improper termination or mismatched baud rates can cause transmission issues.
   CAN Communication Issue – NI Forum
• Bus Monitor Statistics: Enable the statistics toolbar to check for transmit errors or bus load issues.
   NI-XNET Bus Monitor Documentation

Let me know if you’d like help reviewing your session setup or if you can share a screenshot of your Bus Monitor configuration.