State Diagram "Execution Highlighting" does not work in LV 8.2

[Ben]

In older version I could watch the SD to enusre the proper transitions were taking place in the correct order.

I can see the probe show up on the state SR but the SDE does not show that anything is happening!

Ben

Message Edited by Ben on 01-08-2007 10:22 AM

[Wayne.C]

Ben,

I got it to work with a simple diagram on my machine with V8.2 loaded.  Did you just upgrade to 8.2?  Are you targeting hardware?

[DavidJCrawford]

Hi Ben

Like centerbolt I see it working OK too. I tested with PrimeTest.vi example.

David

[Ben]

Thank you David and Ceterbolt!

So I wonder what I will have to do to get it working on my machine .... (rhetorical question)

Ben

[Wayne.C]

Ben,

What version of the State Diagram Toolkit do you have loaded?

[Ben · Accepted solution]

I have "1.0" plus a patch!

I just got off the phone with support for SR 910333.

Yes the SDE execution highlighting works fine

UNLESS

The VI is opened from a project....

Then the execution highlighting does not work!

Ben

[Wayne.C]

You've got my attention now.  I've got "1.0" minus the patch and I'm getting ready to start a project that is going to be state machine intensive.  Does this patch have an name? 

[Ben]

"  Does this patch have an name?  "

Hmm aside from "Here shut-up Ben" I will have to look.

The patch fixes an issue where the SD will become very large and can't be made smaller.

See this thread

http://forums.ni.com/ni/board/message?board.id=170&message.id=217549&jump=true

Ben

Message Edited by Ben on 01-08-2007 01:11 PM

[Wayne.C]

Ben,

Thank you for the info.  I had noticed that little quirk, but didn't pursue it.

Wait, what's that sound?  I think I just heard the merry-go-round start up again.

[Ben]

Thanks for the reminder Centerbolt!

I had never updated that thread to indicate that the fix (for the SDE size issue) did work.

Ben