How do I run code (created in Windows using FPGA Module) in Linux?

[tcmoore]

I have developed a labview project in Windows, using FPGA Module & cRIO.  I want to run it on Linux.  Both computers and cRIO are all connected to the same network.  I have installed Labview 8.6.1 onto a Linux computer.  I copied the project and vi files over to Linux, but when I run the project, Labiew shows an error for my cRIO remote device.  Can I use a cRIO with Labview running on Linux?  What steps are necessary to port the project over to Linux to get it to run?  I have attached a tar of my project. Any answers are greatly appreciated.

Thanks,

Todd Moore

[AdnanZ]

Both real time and fpga are not supported on linux. Have a look at the following links:

How Can I Use LabVIEW Real Time With Linux?

Which products does National Instruments support on Linux?

If you have any follow up questions, please post back.