read the generated signal on speaker using PXI-5412?

[Nabeloabbasi]

hi all

i have some experimental setup in which iam rejecting noise & iam using Labview 2010 & PXI devices

my steps are

1. i have to generate noise signal of frequency 139.65 Hz, 160 Hz and 300 Hz? i have done using  fgen soft front panel & reads it on using PXI-5412 with the noise speaker

2. i have measurement mice and performance mice which use as sensor to read the signal from speaker

i have used   NI scope and NI PXI-5105 digitizer thre channels to see the signals

but i have issue that i want to read signal which is generated using NI scope on my output speaker....

how can i make Vi for that i have search some examples but not getting exact results..

could any one will help me

thanks

[Jonathan_S1]

Hi,

I'd like to clarify your external setup.

1.  Generate signal on 5412 and route to a speaker.

2.  Use microphones as sensors to input signal into 5105.

3.  Acquire signals using 5105 and NI-Scope driver.

You would then like to playback these signals on your speaker.  Are you trying to take your raw data acquired in NI-SCOPE and convert it into some file format that can be played over your speaker?  Or are you trying to take your data and output it using the NI-FGEN soft front panel.

Is the trouble in handling the NI-SCOPE acquired data and manipulating it into a format that you can use?

Jon S