07-02-2008 02:09 PM
07-07-2008 10:02 AM
Hey Rafi,
Are you talking about tracing into sub sequences? You can turn those off in the actual sequence call step. In the Run Options under properties there is a Sequence Call Trace Setting. Set it to Disable Tracing in Sequence.
And make sure in Configure>>Station Options on the Execution tab that you have the Allow Tracing into Sequence Calls Marked with Tracing "Off" unchecked.
Hope this helps.
07-08-2008 12:42 AM
Hi Rafi,
Checkout the Sequence Tracing section of the following link
http://zone.ni.com/devzone/cda/tut/p/id/7559
It may be of use.
Regards
Ray