exponential current

[BlueSky0058]

Hi folks! Hope all is well. A newbie to this form. 🙂

Anyways, I am trying to simulate the circuit below in my multisim. How would I go about declaring the current source as an exponential ( as shown in the diagram) ?

Thanks for all the replies!

[Bcortes]

Hi friend

Concerning your question, since this input current equation is using the time as a parameter, I suggest using a transient analysis. I recommend this link.

Configuring a Transient Analysis in Multisim

https://knowledge.ni.com/KnowledgeArticleDetails?id=kA03q000000YH7lCAG&l=en-US

Additionally, I would like to know if what you mean by u(t) is the unitary step function. I think that probably that may be more difficult to simulate, but not impossible. 

[dbur]

How about the "exponential current" source in the master data base/signal current sources?