Multisim and Ultiboard

cancel
Showing results for 
Search instead for 
Did you mean: 

Transient analys cuts off at .45 sec

Solved!
Go to solution

My transient analysis stops at .45 seconds, and I can't get it to go beyond that.  I have my TSTOP set to someting beyond that (1sec, 2 sec, etc), I have used a variety of TSTEP and TMAX values along with the automatic ones, and I have set the max number of points to 1280000000.  

 

Is there some other setting I am not finding under the transient setup?

 

Joe

0 Kudos
Message 1 of 4
(4,746 Views)

Also, this is using Multisim 14.0...

0 Kudos
Message 2 of 4
(4,745 Views)

I am also getting the error "Transient time point calculation did not converge"

 

I have attached the schematic.  If I remove C5 & C6, it simulates as long as I want. The capacitors seem to be causing the error. 

 

Any help is appreciated!

0 Kudos
Message 3 of 4
(4,708 Views)
Solution
Accepted by topic author Joe1123

Alright, good talk...I ultimately used the SPICE troubleshooting guide off intusoft.com, and relaxed the GMIN.  It seems kind of like a band-aid fix, but at least it simulates now.

 

 

0 Kudos
Message 4 of 4
(4,678 Views)