Home Community Discussion Forums Most Active Software Boards Multisim and Ultiboard Topic

Multisim and Ultiboard

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Problem when using the Agilent Function Generator and the AD633 multiplier circuit.

Problem when using the Agilent Function Generator and the AD633 multiplier circuit.

‎04-23-2017 06:54 PM - edited ‎04-23-2017 06:56 PM

Hi,

 

I have a problem when using the Agilent Function Generator and the AD633 multiplier Circuit in that I get the following simulation error: "A simulation error has occurred. Would you like to run the Convergence Assistant to attempt to resolve this problem automatically?". This error is absent when I use the standard function generator or any of the "Signal Voltage Sources" like the AC_VOLTAGE. I am stuck Smiley Sad.

 

I am using Multisim 14.1 Student edition. The Circuit is attached.

 

Best regards,

Lars

0 Kudos
Message 1 of 1
(2,297 Views)
Reply