07-04-2012 05:56 PM
Hi everyone
I have recently got a new DAQ (data acquisition card) and would like to try it out, however I am not very strong with electronics, so how can I simulate a sensor (pressure sensor, temp. sensor, magnetic sensor… etc.)?
I know that I have to build my own electronic circuit and take out the sensor feedback signal and put it to the DAQ board. Does anyone have a circuit design where sensors are used which I can build and use?
I know it’s a pretty stupid question but I have left electronics for a long time and don’t seem to remember how to get back to it,
I would greatly appreciate if someone could help me or guide me if I am not in the right lines.
Kind regards
Fezz
07-05-2012 02:44 AM
If your data acquisition devices also has Analog Outputs you could simply connect them to the Input channels and simulate your sensor data in software.
Christian
07-06-2012 03:50 AM
Yah it has
thank you for your help,,
best regards