Configuring AT-MIO-16E-1.

[GJAT]

Just recovered from a major disk crash. Re-building m/c from scratch. I have AT-DIO-32F, AT-GPIB.TNT and the AT-MIO-16E-1. The DIO and GPIB are recognised and configured but the DAQ is not. I have two  NI software packages, NI-DAQ for Windows 95/NT/3.1 V4.9.0  (17 diskettes) and Data Aquisition Driver Software V6.5.2 for NT/98/95 (CD).

My operating system is Windows NT 4.0 with service pack 6. Have I got the wrong drivers ? Can you help ?  

[JonBowers]

Hi GJAT

Its been a long time since I installed an AT card on windows NT! I would recomend using the later version of NI DAQ that you have. Have you gone through the procedure of setting the resoruces on the board with the jumpers? If not the manual linked bellow should have information on the installation procedure.

http://www.ni.com/pdf/manuals/320476.pdf

Hope this Helps

Jon B
Applciations Engineer
NI UK & Ireland

[GJAT]

Thank you for your suggestion, however I have an AT-MIO-16E-1, which is fully software configurable unlike the AT-MIO-16 which has numerous jumpers and DIP switches.

Cheers

GJAT