Home Community Discussion Forums Most Active Hardware Boards Motion Control and Motor Drives Topic

Motion Control and Motor Drives

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

re-initialize the data during running the program

re-initialize the data during running the program

‎03-15-2004 08:32 AM

Any function in the Labview that can help me to re-initialize the data during running the program?

Thanks!

Regards,
Ivan
0 Kudos
Message 1 of 2
(2,611 Views)
Reply

Re: re-initialize the data during running the program

‎03-16-2004 11:02 AM

Ivan,

I am not sure if I understand your question. You can reinitialize your board and load different board parameters at any time as a part of your program. This will stop actions on the board and then start over with any movements. Use Initialize Controller.flx VI to do this.

A. Talley
Applications Engineering
National Instruments
0 Kudos
Message 2 of 2
(2,611 Views)
Reply