pc board stepper motors

[i dont know what this is]

i have purchased a dc stepper motor kit that has pc board attached. All i want to do is make some controls for it on labview.  I want it to interface thru labview to increment motor forward and back with just an on and off switch thru labview.. Is there similar examples of this. I have very little experince with labview. thanks

[Jochen]

Hi,

could you please tell me a bit more about your setup? What type of motion control board are you using?

Thanks and best regards,

Jochen Klier
National Instruments

[i dont know what this is]

it will have a basic on off switch to controll forward motion and backward motion.  I do not know any more than that

[Jochen]

Sorry, but in this case I really can't help you. At least you need to tell me what kind of motion control board you are using. Is it an NI-Motion board like the PCI-7330 or the PCI-7340?

Jochen