70129

[k-usa]

Hi ,

     I have an error 70129 << A disabled axis has been commanded to move >>

I work with  :

- Labview 2012

- PCI -7344

- driver NI - MID 7652

- extern encoder 40,000

I use only one axis with servo motor

How can i enable this axis please ?

Thanks

[FuManWho · Accepted solution]

Hi k-usa,

Please make sure that all the hardware is set up, make sure that the enable switch is in the correct position:

https://www.ni.com/docs/en-US/bundle/372902b/resource/372902b.pdf

Also please try to make sure that you can run the motor in Measurement and Automation Explorer  (MAX) before running it in LabVIEW:
https://www.ni.com/docs/en-US/bundle/372324c/resource/372324c.pdf

One thing to note is that this configuration is not the one you want, but will give you a rough idea of how to change setting in MAX.

[k-usa]

 i had a connection probleme

now is ok

thanks!

[henry_huang]

bro.

I use the motion card PCI-7342.

I meet the same problem.(Error 70129)

How do you solve it? pls

[TimothyDug]

Hi henry_huang,

This post is a few years old. I would recommend making a new post on the forums to achieve more visibility.

Best,

[henry_huang]

I found the solution.

Open the NI-MAX, select your devices

and clip the "Initialize" button.