06-20-2015 02:12 AM
Hi Everyone.
I'm a university student. Now I have a project that need to make a new application to get and calculation data from accelerometer such as: geophone, accelemeter, hammer...
I'm aking for example, or tutorial or code.... (something like that). I can get the data from those accelerometer buy useing labview, then I can make a new c# application to calculate the data. However, I need to make a new application which comebine 2 of those requirement by myself to complete my project.
I can make an ni daq application via measurement studion in viasual studio 2010. however, I just only get and export data into 1 grahp(auto code from the measurement studio). It is very inconvinience.
Somebody can help me about this problem.
Thank you in advance.
06-24-2015 09:42 AM
Hello, PaiChai
Are you working with the NI-DAQmx C# examples already? If so, which ones have you used? What specific questions do you have about the code?
Thanks,
06-27-2015 03:25 AM
Thank for your reply. I'm using Ni cdaq-9184 and Ni9234.
I has already learning example in measurementstudiovs2010/dotnet/example/daqmx/analog in/measure acceleration folder.
I want to get the data from 2 accelerometer and hammer in the same time. If I using a waveformgrahp tool in toolbox. I only get 1 frequency signal of 1 accelerometer. I can not (or I don't understand how to use it) to get the second frequency signal of the other accelerometer and the hammer.
Do you have any suggest for me.
Thanks alot
@D-Cubed wrote:
Hello, PaiChai
Are you working with the NI-DAQmx C# examples already? If so, which ones have you used? What specific questions do you have about the code?
Thanks,
06-29-2015 06:37 PM
Hi, PaiChai
I have a few more questions for you:
07-01-2015 09:12 PM
I'm using winform.
It can get the data from 1 accelerometer perfectly.
But 2 accelerometer, i can not plot it into 2 diferent grahp.
07-06-2015 01:52 PM
Can you post the code you are using to read from your DAQ channels?