How to preset the Enable pin functions by software using the frame graber 1422?

[bjsimard]

Hi

I'm looking for any information related to how to configure by software the enable pins on Frame grabber PCI-1422. I found some examples on NI WWW showing that Frame synchronisation signal was wired to Enable A and Line signal synchronisation signal was wired to EnableB.And this was for an Area SCAN type sensor. But in any case that i wish to use my actual setup/cable for a Line SCAN type camera, do I have to modify my cable in order to connect now the Line synchronisation signal on Enable A? Or there is a possibility to define this my software (Camera file for example)

Thank you

regards

Bruno

[Burrito]

Hi bjsimard,

I think your best bet in this case is going to be modifying your cable. I don't think you'll be able to modify your camera file in order to do this.