termination character for serial write

[Bernd-U. Seifert]

Hi there,

(LabView 6.02 on Win2k)
Trying to communicate with a serial device I open a VISA-session on
COM1 and it all works fine except that I'm not able to configure a
termination character.
I've tried the as well as the VISA property
nodes. But I never get the desired termination characters (0xA or 0xD)
sent to the port.

What am I doing wrong?


Thanks in advance,
\Ulli.

[Bernd-U. Seifert]

finally I found out the following:
For the VISA session you have to setup (by means of property nodes)
not only and
but also set to "TermChar". Now everything
works fine 🙂

Bernd-U. Seifert wrote:

> Hi there,
>
> (LabView 6.02 on Win2k)
> Trying to communicate with a serial device I open a VISA-session on COM1
> and it all works fine except that I'm not able to configure a
> termination character.
> I've tried the as well as the VISA property
> nodes. But I never get the desired termination characters (0xA or 0xD)
> sent to the port.
>
> What am I doing wrong?
>
>
> Thanks in advance,
> \Ulli.
>