system exec returning error

[ghan412]

Reaching out to the community once again!

I am attempting to assign a static IP and Subnet Mask to my network adapter so that I can communicate with a device under test. However when I pass the data to the System Exec it returns this error no matter what I change the Mask to. Also if I add a Gateway IP after the Mask it will change the error to 192.168.?.? is not an acceptable value for gateway IP.

Has anyone run into any similar errors?

Thanks

Greg

[nyc_(is_out_of_here)]

Have you tried running that command in a Command Prompt window ?????

This is NOT a LabVIEW question!