04-08-2015 01:40 AM
Hi ,
I am working to synchronize two function generators by LabView.The first function generator is manual triggered while the another one is external triggered like this set up (INFINITE BURST MODE METHOD ) in this link http://www.keysight.com/owc_discussions/thread.jspa?threadID=32427
When I run the code , I see in oscilloscope the first signal from master function generator but , I can not see the signal from the second generator. I found the trigger edge is still off in Function generator while in the code I set it positive edge . I do not know why
I attached the code
Sincerely,
Abdulaziz
04-08-2015 10:19 AM
Hi ,
I attached the updated code
The Function generator is Agilent 33250A
Sincerely,
Abdulaziz
04-09-2015 02:13 PM
Hi Abdulaziz,
Thanks for posting this issue. It may be helpful to include the SubVIs that you're working with as well. I would suggest making sure you've correctly followed all the steps in that link, as there are quite a few to go through, and perhaps switching the which function generator is the master and which is the slave, to ensure it's not an issue with the devices.