programmatically configure teds

[Billy331]

I am trying to configure a teds sensor on a cRIO 9073 I have scan engine enabled on one module and FPGA enabled on the other module I would like to configure TEDS on a sensor in the FPGA Module. My program needs to be a standalone device that returns the force applied to the sensor, I know there is a way to calculate it with the capacity and sensitivity but I am looking for a way to either calibrate the sensor or read the capacity and sensitivity from the sensor. 

Thanks

Billy

[[dk]]

Which modules are you using in the cRIO-9073? Accessing the TEDS information for a module is similiar for all modules, but here are a few resources for you that may help:

http://zone.ni.com/reference/en-XX/help/370984R-01/criodevicehelp/9219_reading_and_writing_teds_info...

http://zone.ni.com/reference/en-XX/help/370984T-01/criodevicehelp/9237_reading_and_writing_teds_info...

http://zone.ni.com/reference/en-XX/help/370984T-01/criodevicehelp/9234_reading_and_writing_teds_info...

http://zone.ni.com/reference/en-XX/help/370984T-01/criodevicehelp/9233_reading_and_writing_teds_info...