LabVIEW

cancel
Showing results for 
Search instead for 
Did you mean: 

linx Raspberry pi connection

I'm very new to Labview. I thought I would start out with a project on my Raspberry Pi 3b+.  When I go to Tools/Makerhub/Linx/Linx Target Configuration and type in {192.168.4.131, raspberrypi and the password}, I get "Device interrogation failed: Unable to connect to the target".  I've rebooted my computer and PI but no change.  I can ping test in either direction.  My computer is running win7 and my Labview is 2014.  Any advise to help me connect?

0 Kudos
Message 1 of 3
(2,689 Views)

Hi,

 

      Its probably because it can't find the right information of the Rapsberry Pi. The linx was built for Pi Gen. 2&3. Well, you can also install manually using "sudo" options. 

 

This is just a guess, below information gives clear picture. 

Hardware pi 3b+ = BCM2837B0

Hardware pi 2&3 = BCM2837 

 

Well ,the Labview program just compares the string of CPU and if it matches you won't have this Device interogation issue.

0 Kudos
Message 2 of 3
(2,647 Views)

did you enable SSH in Raspberry Pi configuration?

0 Kudos
Message 3 of 3
(2,410 Views)