Home Community Discussion Forums Most Active Software Boards LabVIEW Topic

LabVIEW

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

keeping the correct power after saving the data

keeping the correct power after saving the data

‎02-15-2006 11:01 AM

I got a question about the data saved with the scope 5124 in I16 format

the data is downcoverted with the 5600, and than saved with the scope...but how can i transfer the correct levels, or recalculate the correct power levels..?

thanks

Joost van Heijenoort
0 Kudos
Message 1 of 2
(2,035 Views)
Reply

Re: keeping the correct power after saving the data

‎03-29-2006 09:41 AM

I allready found out how to do this...

a now save with the data the Gain and offset from the scope, if you than later do the following

Y=data*gain + offset

the data is to the correct power level restored..

regards

Joost
0 Kudos
Message 2 of 2
(2,004 Views)
Reply