LabVIEW

cancel
Showing results for 
Search instead for 
Did you mean: 

daq assistant properites won't open

Solved!
Go to solution

We are using version 8.0.1 LV with daqmx version 8.7.1. Win Xp with a PCI-6025E card, SCB-100 is attached. I can measure the thermistor in the SCB-100 in Measurement and Automation so the hardware seems to work OK. The problem is using Daqmx in LV. I'm following the tutorial at http://zone.ni.com/devzone/cda/tut/p/id/2744 . When I drop the Daq Assistant onto the Block diagram it does not open the properties page to allow me to configure an analog input, double click won't work, single click and selecting properties does nothing. In Measurement and Automation I can create a task and it does launch the daq-mx box and setup measuring with the PCI-6025E. Probably a simple setting issue somewhere, any ideas ?

0 Kudos
Message 1 of 3
(4,283 Views)
Solution
Accepted by topic author sstewart

See this discussion and this one.

 

Hope this helps

Now Using LabVIEW 2019SP1 and TestStand 2019
0 Kudos
Message 2 of 3
(4,270 Views)

Thanks, those links helped. Basically going to windows control panel, mod/del National Instruments, delete Daqmx, reboot, re-install daqmx and it works. I think there were other versions mixed in with 8.7.1.

 

0 Kudos
Message 3 of 3
(4,243 Views)