Using labview signalexpress as a scope

[edoson]

Hey all,

I'm using NI-6009 to aquire signals from a sensor, And i needed some kind of a graphical representation program, mainly for demonstartion issues. This is way I tried to use signalexpress, which i find very convinient  My only problem is that I can't see the data in RT as in a scope, i can only see it block by block, with each block plotting running over the plot of the previous block...

What i wish to see is, as in a scope, a time line which i can configure (Say 10 sec) and the signal advancing on this time line, until it reaches it's end, and then the process begins again from the beginning of the time line...  Is this possible with signalexpress? Or should I write my own GUI for presentation purposes?

Thx for any answers... 

[Dennis_Knutson]

duplicate post to wrong board

[edoson]

Sorry... 🙂