From Friday, April 19th (11:00 PM CDT) through Saturday, April 20th (2:00 PM CDT), 2024, ni.com will undergo system upgrades that may result in temporary service interruption.

We appreciate your patience as we improve our online experience.

Home Community Discussion Forums Most Active Software Boards LabVIEW Topic

LabVIEW

cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Using a Trigger to change state on a Relay

Using a Trigger to change state on a Relay

‎08-12-2014 10:36 AM

Labels:

Hello - I am new at LabVIEW and I am trying to use a voltage fall  to change state in a relay - Not sure how to do this and I have look around and can not find anything on how to do this. Here is the program that I am trying to fit my needs

 

Thanks for any one that can help

 

0 Kudos
Message 1 of 2
(2,849 Views)
Reply

Re: Using a Trigger to change state on a Relay

‎08-12-2014 11:14 AM - edited ‎08-12-2014 11:14 AM

How are you acquiring the Voltage? Are you using a DAQ card or you are trying to use the Voltage to switch the relay? Please explain your hardware setup

-----

The best solution is the one you find it by yourself
0 Kudos
Message 2 of 2
(2,837 Views)
Reply